Abstract:
Among the second generation thin film photovoltaics, CdS/CdTe based solar cell
device is one of the leading contenders for large scale commercialization. Since the
CdTe is the crucial absorber material of the foregoing device, it is essential to
maintain a well-adhered CdTe layer to obtain high photovoltaic activities. If not,
loosened CdTe layers with numerous pinholes can reduce the electrical, optical,
structural and morphological properties of the material and hence extinguish the
entire activities of CdS/CdTe solar cells.
In the present study, an electrodeposition procedure was developed to fabricate welladherent
CdTe layers to the substrate using the typical three electrode electrolytic
cell. A fluorine doped tin oxide conducting glass substrate (7Ω/sq.) with dimensions
of (1×3) cm2 was used as the working electrode in the cell. A saturated calomel
electrode and a high purity graphite rod served as reference and counter electrodes
respectively. All the electrodepositions were carried out using an aqueous solution
containing 1.0 mol/L CdSO4, 1.0 mmol/L TeO2 and 5.5 mmol/L CdCl2. Based on the
cyclic voltammetry studies and the stoichiometry of the proposed chemical reaction
which forms CdTe material, the possible cathodic deposition potential (CDP) and pH
ranges were identified to be in the ranges of 550-710 mV and 1.4-2.4 respectively.
Henceforth, CdTe layers were electrodeposited at above mentioned conditions at
temperature of 65 °C and subsequently annealed in air at 400 °C for 10 min.
Thereafter, by considering the physical appearance of deposited CdTe layers and
their adhesiveness upon a high pressure N2 flow, the feasible values for CDP and pH
were found to be in the ranges of 590-660 mV and 2.0-2.4 respectively. To further
fine-tune the values for CDP and pH, a series of CdTe layers were deposited at above
feasible growth conditions and inspected for their electrical, optical, structural and
morphological properties using the methods of photo-electrochemical cell, optical
absorption spectroscopy, X-ray diffraction and scanning electron microscopy
respectively. Results revealed that, the optimum CDP is in the range of 620-660 mV
and pH is in the range of 2.1-2.3 to exhibit good photovoltaic qualities.
